Onewheel Pint Footpad Replacement

Difficulty: Easy

Steps: 3

Time Required: 15 minutes

Introduction

If your Onewheel Pint footpads are damaged, failing, or you’re just ready for a new set, use this guide to help you swap them out and get back to riding!

For your safety, power off your Onewheel Pint prior to disassembly. This reduces the risk of electrical malfunctions and/or damage during the replacement process.

Note: Altering or damaging any component of your Onewheel Pint during disassembly/reassembly may render your existing warranty void or lead to refusal of non-warranty service at the discretion of Future Motion, Inc. (the creators of Onewheel).

Step 1 Remove the bottom front and rear bumper screws

Remove all eight (8) screws using a TP20 bit.
Note: DO NOT remove the front bottom bumper screws closest to the tire.

Step 2 Remove the top footpad screws

Remove all four (4) screws using a TP20 bit.

Step 3 Remove the footpads

Caution: For the front footpad sensor connector, turn (counter-clockwise) only the smaller part of the connector closest to the controller. Turning the entire body of the connector can damage it or your controller.
Note: If you are unable to remove the footpad sensor connector using your fingers, you may use a Future Motion™ footpad connector wrench or a pair of long nose pliers (be gentle).