Onewheel Pint Bumper Replacement

Difficulty: Easy

Steps: 2

Time Required: 15 minutes

Introduction

If your Onewheel Pint bumpers are worn down, broken, or you’re just ready for a new color, use this guide to swap them out and keep your investment protected!

For your safety, power off your Onewheel Pint prior to disassembly. This reduces the risk of electrical malfunctions and/or damage during the replacement process.

Note: Altering or damaging any component of your Onewheel Pint during disassembly/reassembly may render your existing warranty void or lead to refusal of non-warranty service at the discretion of Future Motion, Inc. (the creators of Onewheel).

Step 1 Remove the bottom bumper screws

Remove all ten (10) screws using a TP20 bit.
Note: Keep screws organized as they are easy to mix up and/or lose.

Step 2 Remove the bumpers

To remove the front bumper, pull it toward the nose of the Onewheel™.
To remove the rear bumper, pull it toward the tail of the Onewheel™.
Note: If you are unable to remove the rear bumper by hand, you may use a flat head screwdriver to pry it away from the rails (be gentle).