Onewheel GT Bluetooth Calibration

Written By: Justin Velasquez

Difficulty: Easy

Steps: 7

Time Required: 10 minutes

Introduction

If you’ve recently installed aftermarket rails, a replacement BMS, or disconnected the battery of your Onewheel GT, it may be necessary to re-calibrate the board to ensure optimal performance. Use the guide below to re-calibrate your Onewheel GT and get back to shredding!

Important: This process is not compatible with firmware version Cassiopeia – 6132 or above.

Note: Completing this process may render your existing warranty void or lead to refusal of non-warranty service at the discretion of Future Motion, Inc. (the creators of Onewheel).

Step 1   Open this guide in a mobile Bluetooth enabled browser

  • iOS – Download the Webler app and paste this guide’s URL into the in-app browser.
  • Android – *Incompatible
  • Desktop – *Incompatible

*Requires ‘Remove BLE Handshake Check’

Step 2   Power on the Onewheel

  • Once you have powered on your Onewheel, proceed to Step 3.

Step 3   Open the Onewheel app and minimize it

  • Important: DO NOT connect to your Onewheel via the Onewheel app and
  • Important: DO NOT close the app. Simply, minimize it.
  • Download the iOS App

Step 4   Connect to the Onewheel via the mobile browser

  • This is necessary to pair the Onewheel to your mobile Web Bluetooth browser.
  • Click the CONNECT button below to connect!
  • Note: Make sure you are not connected to your Onewheel via the Onewheel app or it will not show up in the device list.

Step 5   Connect to the Onewheel via the Onewheel app and minimize it

  • Important: DO NOT close the app. Simply, minimize it and return to the guide in your mobile browser.

Step 6   Complete the calibration process

  • Important: BEFORE completing the BMS + Level calibration, make sure your Onewheel is oriented at your preferred riding level.
  • Click the buttons below, in order, to complete the calibration process!

Step 7   Power cycle the Onewheel

  • To power cycle the Onewheel, simply turn it off and back on.
  • Note: The ride mode and headlight status (on/off) may reset after completing the calibration process. They can be changed back manually at this time.

© 2024 FixMyPEV ™  All Rights Reserved.