Onewheel Pint X Bumper Replacement

Difficulty: Easy

Steps: 2

Time Required: 15 minutes

Introduction

If your Onewheel Pint X bumpers are worn down, broken, or you’re just ready for a new color, use this guide to swap them out and keep your investment protected!

For your safety, power off your Onewheel Pint X prior to disassembly. This reduces the risk of electrical malfunctions and/or damage during the replacement process.

Note: Altering or damaging any component of your Onewheel Pint X during disassembly/reassembly may render your existing warranty void or lead to refusal of non-warranty service at the discretion of Future Motion, Inc. (the creators of Onewheel).

Step 1 Remove the bottom bumper screws

Remove all ten (10) screws using a TP20 bit.
Note: Keep screws organized as they are easy to mix up and/or lose.

Step 2 Remove the bumpers

To remove the front bumper, pull it toward the nose of the Onewheel™.
To remove the rear bumper, pull it toward the tail of the Onewheel™.
Note: If you are unable to remove the rear bumper by hand, you may use a flat head screwdriver to pry it away from the rails (be gentle).